MUSIC HALL ikura Instruction Manual Page 1

music hall ikura INSTRUCTION MANUAL music hall http://www.musichallaudio.com

10 All cartridges with half inch mounting holes can be fitted. Leaving the stylus guard on, fit the cartridge to the head shell (19) using the scr

11 Azimuth Adjustment: Azimuth is the angle of the stylus to the record groove. Viewed from head-on. You want the stylus to be perpendicular to t

12 OPERATION Place a record on the platter (5) and push the mains switch (18) to the 'ON' position. Remove the stylus guard and lift up t

13 OIL - The oil supplied for the main bearing provides life-long protection. If oil is lost from the bearing housing, replace it with a few drops of

14 CARTRIDGE SPECIFICATIONS – ortofon 2m blue Output voltage at 1000 Hz, 5cm/sec: 5.5 mV Channel balance at 1 kHz: 1.5 dB Channel separation at 1 kH

15 LOUD HUM ON PHONO INPUT: • No earth connection from cartridge, tonearm, or audio cable to amplifier. • Ground loop. • Turntable too close to on

16

17 WARRANTY This entitles you to have the music hall ikura repaired free of charge, at our discretion, for one year after the date of purchase, at an

2 CONGRATULATIONS ON YOUR PURCHASE You have selected an exceptional turntable. Each component used in the construction of the music hall ikura was s

3 6. Racks and Stands Place the turntable on a fixed, level surface strong enough to support its weight. Do not place it on a moveable cart that c

4

5 Parts Inventory and Operation Control Diagram 1. 2 x removable transport screws 2. 1 x stepped motor pulley 3. 1 x drive belt (packaged in

6 Parts bag includes: 1 x 45 rpm adapter 1 x drive belt (3) 1 x anti-skate weight (15) (tiny weight attached to small piece of fishing line) 1 x belt

7 FOR YOUR INFORMATION This manual provides valuable information that will help you get optimum performance from your system. Please contact your au

8 9. Make sure the tonearm (9) is in the tonearm rest (8). Carefully, remove the stylus guard if fitted (the piece of clear plastic on the bottom

9 IMPORTANT Do not touch the tracking force scale again. Turn the counterweight counterclockwise with your right hand. You will notice that the tra